User Manual

continued on next page
12
Changing Buckle Position
11
Locate the Buckle’s
Metal Retainer
The buckle’s metal retainer is
located in the opening below the recline
handle.
Push the harness adjustment
strap to the side to fully reveal
the metal retainer.
3
4
Rotate Metal Retainer and Push
It Up Through Buckle Slot in
Shell
5
Fully Recline the Car Seat
Place one hand on the back of the car
seat. With your other hand, squeeze the
recline handle and rotate the car seat
until it is fully reclined.
Unbuckle Harness
Press in towards the top of the red
button to release the buckle tongues.
Buckle Tongue
2
Harness
Adjustment
Strap
Metal Retainer
From Top of Seat,
Pull Buckle and Buckle
Cover Out of Shell and Pad
6
Recline
Handle
Fully Loosen Harness Straps
Place your hand between the harness
cover and harness strap. You may need
to undo the harness cover or move the
chest clip down. Push down on harness
release lever (through opening in pad)
while pulling out on harness straps as
shown.
1
Slide Buckle Cover into Chosen
Slot in Pad
Buckle must face out.
Rear-Facing Mode: You must use the
1st or 2nd buckle slots.
Forward-Facing Mode: Any slot can be
used.
Buckle cover only goes through slot in
pad. It lays fl at underneath the pad as
shown.
1
2
3
7