Operation Manual

39
Lower connectors installation
(if tted)
• Make sure level line on side of child restraint is
level with ground. Adjust base if needed
(see page 19).
• You may need to place a large rolled towel(s) or
foam pool noodle(s) under the front of the base to
achieve correct recline angle.
• Check often to be sure padding is still in place, the
level line is still level and the belt is tight.
• Remove lower connectors from vehicle anchors by
pressing the red release button on each connector.
NOTE: The carrying handle can be in any
position when installed in the vehicle.
Failure to securely attach child restraint to base can result in serious injury
or death.
WARNING