Operation Manual

Recording Music
27
Since pressing the RECORD

button during MUSIC/VIDEO/RADIO/PHOTO playback does not
start recording, press the

button to move to the previous menu and to the main menu.
1
Connect the Line Out jack of the external audio equipment and the AV IN jack of
the unit with the Line In cable.
2
Press the RECORD

button on the left side of the unit.
3
Select AUDIO Recording using the + / – buttons and press the button to start music recording.
● Press the button to pause recording.
Press the
button once again to resume recording.
4
To stop recording, press the

button while recording voice.
● This returns to the previous menu and saves the recorded voice as a file.
☞
Note
●
After recording, the recorded files are automatically saved in the AUDIO folder within the RECORD folder of the
MUSIC menu. If the AUDIO folder does not exist, the AUDIO folder is automatically created.
●
The recorded music is saved as an MP3 file in the sequence of AUDIO000, AUDIO001, and so on.
●
You can create up to 1000 files (000 ~ 999).
●
While recording, the volume cannot be changed.
●
When the memory is full, recording is automatically stopped.
●
For procedures to configure the sound quality of audio, refer to page 51.
☞
Notice
●
When the remaining battery charge is too low, recording is not possible.
●
Adjust the volume of the external audio equipment to an appropriate level before
recording music. If the volume is too high or low, the sound quality of the recorded music may not be good.
●
The supplied Line In cable can only be used to connect an external audio device for audio recording.
Connect the white plug of +(4-pole) to AV In jack and connect the black plug of
+(3-pole) to Line Out jack of an external audio device. If the jacks are not connected to the
corresponding ports, recording will not properly be done.

44.1KHz 128kbps
FILENAME : AUDIO000.MP3
AUDIO
RECORD
Press PLAY to Start
44.1KHz 128kbps
FILENAME : AUDIO000.MP3
0:00:20
AUDIO
RECORD
REC
