User's Manual

C H A P T E R 1
G E T T I N G T O K N O W Y O U R I D L 3 I D
Product User Guide 8
Resetting off the iDL3ID
To reset the iDL3ID, hold down the <POWER> key for approximately 4-5 seconds (as shown in figure 1-2). Select the “Power down” option from the
menu as shown in figure 1-3. The iDL3ID will create a restore point to save all registry and related installed information before shutting the unit
down.
The device can also be reset by pressing the <POWER> key and the <CLR> key and the <ENTER> key simultaneously (i.e. all at once) for
approximately three to four seconds, until the display is blanked.
When the device is started from a complete shutdown state, the boot-up menu provides various options allowing for the device to be configured in
different ways (for example restoring it to its default factory settings). Contact your product/service provider for more detail on the management of
the boot-up sequence and options (for example when it is desired to clear the device and restore it to its default factory settings).
FIGURE 1-2 FIGURE 1-3
Charging a battery via the iDL3ID
The iDL3ID and docking station was designed to allow the user to charge a battery that is inserted
into the iDL3ID. This can be done by inserting a battery into the iDL3ID and then placing the iDL3ID
on a docking station that is powered up as shown in the figure on the left.
When on the docking station, the LED located to the left of <SCAN> key turns on. This indicates that
power is supplied to the iDL3ID and that the battery is being charged.
While the iDL3ID is on the docking station, it can be operated as normal.
Never dock the iDL3ID without inserting a battery. The iDL3ID on the docking station without a battery may cause some
functional errors.
At all times – Switch off the iDL3ID before docking it for charging purposes.
Charging status is indicated on the iDL3ID by a battery with lightning icon in the system tray.