User's Manual

C H A P T E R 1
G E T T I N G T O K N O W Y O U R I D L 3 I D
Product User Guide 2
Using the iDL3ID
The Docking Station
The Docking Station shown above is used to charge an iDL3ID battery and can charge a battery that is inserted in the iDL3ID. The docking station
requires a 12V DC power supply in order to operate. This is supplied by the PSU.
Connecting power to the docking station
First, the power lead must be connected into the three-prong connector on the PSU. The power lead plug must then be connected to a power source
and the power source switched on.
When a green LED is present on the PSU, it should light up to indicate power is present and the PSU is functioning. If the green LED does not light
up, please check that the power is properly inserted into the PSU and into the power source and the power source is switched on.
Connect the functional PSU into the docking station by plugging the DC Jack into the connecter marked “12V D.C.”
The green LED’s marked “Power” and “Charged” on the docking station will light up to indicate power is present and that docking station is
functional.
Inserting a battery
The iDL3ID is supplied with 4.2V, 2200mAh batteries.
In order to charge a battery it must first be inserted into the slot in the docking station as shown above.