User's Manual

C H A P T E R 1
G E T T I N G T O K N O W Y O U R I D L 3 I D
Product User Guide 3
Battery Charging & LED Indicators
The docking station has three LED’s. There are two green LED’s marked “Power” & “Charged” and one red LED marked “Charging.”
The LED’s indicate the following:
When powered on with no battery inserted the “Power” LED illuminates, the “Charging” LED turns on briefly and the “Charged” LED
then turns on. The “Power” LED remains on for as long as power is supplied to the docking station.
On inserting an uncharged battery into the docking station. The “Charged” LED switches off and the “Charging” LED turns on. This
indicates that a charge cycle has begun and the inserted battery is being charged.
When the docking station detects that the charging battery has reached full charge. The “Charging” LED turns off and the “Charged” LED
turns on, indicating the charge cycle has ended and the battery is now fully charged.
On inserting a battery that is already fully charged, the “Charged” LED will remain on to indicate that the battery does not need charging.
Inserting the battery into the iDL3ID
Insert the battery into the iDL3ID as shown below
At all times - Switch off the iDL3ID before removing the battery.
Before using the iDL3ID for the first time, both backup internal and removable external batteries MUST be charged. The
initial charging cycle for both batteries is approximately twelve (12) hours. Subsequent charging cycles will take up to a
maximum of four and a half hours.
If the battery is removed from the iDL3ID or completely discharged, there is a ten (10) minute window in which to insert a
charged battery or charge the discharged battery before the time & date settings are lost and losing current application
data.
Use only the correct batteries, PSU and docking station supplied by a MaxID dealer. The use of other equipment can
cause permanent damage to the iDL3ID and render the warranty void. For correct supplies contact a MaxID Dealer or visit
www.maxidgroup.com
Charged
Power
Charging