User Manual

U S I N G T H E I D L 7 5 0
Product User Guide
16
Working with the IDL750 batteries
Using the Battery Charger
The Battery charger can be used to charge an IDL750 battery outside of the IDL750 device. To operate, the battery charger requires a 24V 2.5A DC
power supply unit (PSU) supplied with the IDL750.
Connecting power to the battery charger
Place the charger on a flat, level surface away from sources of heat and moisture. Plug the supplied AC power cable into the three-prong connector
on the 24V 2.5A AC Power Supply Adaptor. Then connect the power lead to a mains AC power source. Connect the functional PSU into the battery
charger by plugging the DC Jack into the connecter and switch the mains AC power source on.
For illustration and clarification, refer to the illustrations under “Accessories” as per previous section of this manual
Inserting a battery and Charging
The IDL750 is supplied with 10.8V, 2000mAh batteries.
In order to charge a battery via the battery charger, place the battery into the Battery Bay ensuring that the 5-way connector is fully seated in the
battery charger as shown above.
The LEDs in the Status Window of the charger will provide status information and the charger will automatically begin charging. Charging a battery
via the charger will take up to two and a half hour.
Use only the correct batteries, PSU and battery charger supplied by a MaxID Corp dealer. The use of other equipment can
cause permanent damage to the IDL750 and render the warranty void. For correct supplies contact a MaxID Corp Dealer
or visit www.maxid.net