Data Sheet

LoRa Concentrator Card_GL5712-UX_Datasheet_V1.0.0
Shenzhen Zaina Technology Co.,Ltd - 7 -
manufacturers should not assume that because
the modular transmitter is certified that they do not have any responsibility for final product compliance.
c) If the investigation indicates a compliance concern the host product manufacturer is obligated tomitigate the
issue. Host products using a modular transmitter are subject to all the applicable individual technical rules as well
as to the general conditions of operation in Sections 15.5, 15.15, and 15.29 to not cause interference.
The operator of the host product will be obligated to stop operating the device until the interference
have been corrected .
Additional testing, Part 15 Subpart B disclaimer
The final host / module combination need to be evaluated against the FCC Part 15B criteria for unintentional radiators
in order to be properly authorized for operation as a Part15 digital device. The host integrator installing this module
into their product must ensure that the final composite product complies with the FCC requirements by a technical
assessment or evaluation to the FCC rules, including the transmitter operation and should refer to guidance in KDB
996369. For host products with certified modular transmitter, the frequency range of investigation of the composite
system is specified by rule in Sections 15.33(a)(1) through (a)(3), or the range applicable to the digital device, as shown
in Section 15.33(b)(1), whichever is the higher frequency range of investigation. When testing the host product, all the
transmitters must be operating. The transmitters can
be enabled by using publiclyavailable drivers and turned on, so
the transmitters are active. In certain conditions it might beappropriate to use a technology-specific call box (test set)
where accessory devices or drivers are not available. When testing for emissions from the unintentional radiator, the
transmitter shall be placed in the receive mode or idle mode, if possible. If receive mode only is not possible then, the
radio shall be passive (preferred) and/or active scanning. In these cases, this would need to enable activity on the
communication BUS (i.e., PCIe, SDIO, USB) to ensure the unintentional radiator circuitry is enabled. Testing
laboratories may need to add attenuation or filters depending on the signal strength of any active beacons (if
applicable) from the enabled radio(s). See ANSI C63.4, ANSI C63.10 and ANSI C63.26 for further general testing details.
5. Package
Table5.1 packge
6. Contact Us
Shenzhen Zaina Technology Co., Ltd
Tel:[phone]
Office address : Room 302, 3F, No.16, Lane 1, Liuxian No.2 Road, Bao'an District, Shenzhen, Guangdong, China
Module
Package
Article number
Form QTY Size
GL5712-UX Trays As required As required Undetermined