Owner manual

71M6511/71M6511H Quick Start Guide
Revision 1.1 2 of 2
© Copyright 2004-2005 TERIDIAN Semiconductor Corporation
Demo Board Test Setup
The file DBUM6511.pdf is a document containing detailed instructions on how to set up and use the Demo Board.
This document should be carefully read
and understood before attempting to use the Demo Board.
The figure below shows the basic connections of the Demo Board plus Debug Board with the external equipment.
Power
Host PC
Debug
Board
Demo
Board
Spacer
removed
Using the Demo Board
The Demo Board is a ready-to-run meter with a Kh of 1.0 Wh/pulse (if used with a CT with a 2,000:1 winding ratio).
The Demo Board has been tested on a meter calibration system, but it has not been calibrated
. Please refer to the
Demo Board User’s Manual for further details and on how to configure the Demo Board for shunt configuration.
Documentation
All data sheets, user’s manuals and user’s guides are in electronic form, i.e. on the CD-ROM supplied with this kit.
The TERIDIAN Semiconductor web site should be checked frequently for updates.
Software/Utilities
Demo code, source files, and libraries can be found in electronic form on the supplied CD-ROM. The CD-ROM also
contains all tools and utilities described in the documentation.
Support
Support is available from:
TERIDIAN Semiconductor Corporation
6440 Oak Canyon Rd.
Irvine, CA 92618-5201
Phone: [phone] ▪ Fax: [phone]
http://www.teridian.com/
[e-mail]
TERIDIAN Semiconductor Corporation makes no warranty for the use of its products, other than expressly contained in the
Company’s warranty detailed in the TERIDIAN Semiconductor Corporation standard Terms and Conditions. The company
assumes no responsibility for any errors which may appear in this document, reserves the right to change devices or specifications
detailed herein at any time without notice and does not make any commitment to update the information contained herein.