Datasheet

71M6513/71M6513H

3-Phase Energy Meter IC

DATA SHEET

SEPTEMBER 2011

A Maxim Integrated Products Brand

Refreshing the WD Timer: The watchdog timer must be refreshed regularly to prevent the reset request signal from

becoming active. This requirement imposes an obligation on the programmer to issue two instructions. The first instruction

sets WDT and the second instruction sets SWDT. The maximum delay allowed between setting WDT and SWDT is 12 clock

cycles. If this period has expired and SWDT has not been set, WDT is automatically reset, otherwise the watchdog timer is

reloaded with the content of the WDTREL register and WDT is automatically reset. Since the WDT requires exact timing,

firmware needs to be designed with special care in order to avoid unwanted WDT resets. Teridian strongly discourages the

use of the software WDT.

Special Function Registers for the WD Timer

Interrupt Enable 0 Register (IEN0):

MSB LSB

EAL WDT ET2 ES0 ET1 EX1 ET0 EX0

Table 25: The IEN0 Register (see also Table 32)

Bit

Symbol

Function

IEN0.6 WDT Watchdog timer refresh flag.

Set to initiate a refresh of the watchdog timer. Must be set directly before SWDT is

set to prevent an unintentional refresh of the watchdog timer. WDT is reset by

hardware 12 clock cycles after it has been set.

Table 26: The IEN0 Bit Functions (see also Table 32)

Note: The remaining bits in the IEN0 register are not used for watchdog control

Interrupt Enable 1 Register (IEN1):

MSB LSB

EXEN2 SWDT EX6 EX5 EX4 EX3 EX2

Table 27: The IEN1 Register (see also Tables 30/31)

Bit

Symbol

Function

IEN1.6 SWDT Watchdog timer start/refresh flag.

Set to activate/refresh the watchdog timer. When directly set after setting WDT, a

watchdog timer refresh is performed. Bit SWDT is reset by the hardware 12 clock

cycles after it has been set.

Table 28: The IEN1 Bit Functions (see also Tables 30/31)

Note: The remaining bits in the IEN1 register are not used for watchdog control