Datasheet

DS1077
16 of 21
AC ELECTRICAL CHARACTERISTICS: 2-WIRE INTERFACE
(-40°C to +85°C; V
CC
= 5V±5%)
PARAMETER SYMBOL CONDITION MIN TYP MAX UNITS NOTES
Fast Mode 400 SCL Clock Frequency f
SCL
Standard Mode 100
kHz
Fast Mode 1.3 Bus Free Time
Between a STOP
and START Condition
t
BUF
Standard Mode 4.7
µs
Fast Mode 0.6 Hold Time (Repeated)
START Condition
t
HD:STA
Standard Mode 4.0
µs 6
Fast Mode 1.3 LOW Period of SCL t
LOW
Standard Mode 4.7
µs
Fast Mode 0.6 HIGH Period of SCL t
HIGH
Standard Mode 4.0
µs
Fast Mode 0.6 Set-Up Time for a
Repeated START
t
SU:STA
Standard Mode 4.7
µs
Fast Mode 0 Data Hold Time t
HD:DAT
Standard Mode 0
0.9 µs 7,8
Fast Mode 100 Data Set-Up Time t
SU:DAT
Standard Mode 250
ns
Fast Mode 300 Rise Time of Both
SDA and SCL Signals
t
R
Standard Mode
20 + 0.1C
B
1000
ns 9
Fast Mode Fall Time of Both SDA
and SCL Signals
t
F
Standard Mode
20 + 0.1C
B
300 ns 9
Fast Mode 0.6 Set-Up Time For STOP t
SU:STO
Standard Mode 4.0
µs
Capacitive Load for
Each Bus Line
C
B
400 pF 9
Input Capacitance C
I
5 pF
NONVOLATILE MEMORY CHARACTERISTICS
PARAMETER SYMBOL CONDITION MIN TYP MAX UNITS NOTES
Writes +85°C 10,000
NOTES:
1) All voltages are referenced to ground.
2) 8.13kHz is obtained from a -66MHz standard part.
3) PDN is a power-down signal applied to either CTRL0 or CTRL1 pins as appropriate.
4) Output voltage swings may be impaired at high frequencies combined with high output loading.
5) After this period, the first clock pulse is generated.
6) A device must internally provide a hold time of at least 300ns for the SDA signal (referred to the V
IH MIN
of the SCL signal) in order to bridge the undefined region of the falling edge of SCL.
7) The maximum t
HD:DAT
has only to be met if the device does not stretch the LOW period (t
LOW
) of the SCL
signal.