Manualshelf

Instruction Manual

ManualsBrandsMaxim Integrated ManualsComputer AccessoriesDS33R11
171172173174175176177178179180
DS33R11 Ethernet Mapper with Integrated T1/E1/J1 Transceiver
172 of 344
Register Name:
LI.RX86LSIE
Register Description:
Receive X.86 Interrupt Enable
Register Address:
123h
Bit # 7 6 5 4 3 2 1 0
Name - - - - SAPINE01IM SAPINEFEIM CNE3LI
M
ANE4IM
Default 0 0 0 0 0 0 0 0
Bit 3: SAPI Octet not equal to
LI.TRX86SAPIH Interrupt Enable (SAPINE01IM) If this bit is set to 1,
LI.RX86S.SAPIHNE will generate an interrupt.
Bit 2: SAPI Octet not equal to
LI.TRX86SAPIL Interrupt Enable (SAPINEFEIM) If this bit is set to 1,
LI.RX86S.SAPILNE will generate an interrupt.
Bit 1: Control not equal to
LI.TRX8C Interrupt Enable (CNE3LIM) If this bit is set to 1, LI.RX86S.CNE will
generate an interrupt.
Bit 0: Address not equal to
LI.TRX86A Interrupt Enable (ANE4IM) If this bit is set to 1, LI.RX86S.ANE will
generate an interrupt.
Register Name:
LI.TQLT
Register Description:
Serial Interface Transmit Queue Low Threshold (Watermark)
Register Address:
124h
Bit # 7 6 5 4 3 2 1 0
Name TQLT7 TQLT6 TQLT5 TQLT4 TQLT3 TQLT2 TQLT1 TQLT0
Default 0 0 0 0 0 0 0 0
Bits 0 - 7: Transmit Queue Low Threshold (TQLT[0:7]) The transmit queue low threshold for the connection, in
increments of 32 packets of 2048 bytes each. The value of this register is multiplied by 32 * 2048 bytes to
determine the byte location of the threshold. Note that the transmit queue is for data that was received from the
Serial Interface to be sent to the Ethernet Interface.
Register Name:
LI.TQHT
Register Description:
Serial Interface Transmit Queue High Threshold (Watermark)
Register Address:
125h
Bit # 7 6 5 4 3 2 1 0
Name TQHT7 TQHT6 TQHT5 TQHT4 TQHT3 TQHT2 TQHT1 TQHT0
Default 0 0 0 0 0 0 0 0
Bits 0 – 7: Transmit Queue High Threshold (TQHT[0:7]) The transmit queue high threshold for the connection,
in increments of 32 packets of 2048 bytes each. The value of this register is multiplied by 32 * 2048 bytes to
determine the byte location of the threshold. Note that the transmit queue is for data that was received from the
Serial Interface to be sent to the Ethernet Interface.