Datasheet

MAX1020/MAX1022/MAX1057/MAX1058
10-Bit, Multichannel ADCs/DACs with FIFO,
Temperature Sensing, and GPIO Ports
8 _______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS (continued)
(V
AVDD
= V
DVDD
= 2.7V to 3.6V (MAX1057), external reference V
REF
= 2.5V (MAX1057), V
AVDD
= V
DVDD
= 4.75V to 5.25V
(MAX1020/MAX1022/MAX1058), external reference V
REF
= 4.096V (MAX1020/MAX1022/MAX1058), f
CLK
= 3.6MHz (50% duty cycle),
T
A
= -40°C to +85°C, unless otherwise noted. Typical values are at V
AVDD
= V
DVDD
= 3V (MAX1057), V
AVDD
= V
DVDD
= 5V
(MAX1020/MAX1022/MAX1058), T
A
= +25°C. Outputs are unloaded, unless otherwise noted.)
Note 1: Tested at V
DVDD
= V
AVDD
= +3.6V (MAX1057), V
DVDD
= V
AVDD
= +5.25V (MAX1020/MAX1022/MAX1058).
Note 2: Offset nulled.
Note 3: No bus activity during conversion. Conversion time is defined as the number of conversion clock cycles multiplied by the
clock period.
Note 4: See Table 5 for reference-mode details.
Note 5: Not production tested. Guaranteed by design.
Note 6: See the
ADC/DAC References section.
Note 7: Fast automated test, excludes self-heating effects.
Note 8: Specified over the -40°C to +85°C temperature range.
Note 9: REFSEL[1:0] = 00 and when DACs are not powered up.
Note 10: DAC linearity, gain, and offset measurements are made between codes 115 and 3981.
Note 11: The DAC buffers are guaranteed by design to be stable with a 500pF load.
Note 12: Time required by the DAC output to power up and settle within 1 LSB in the external reference mode.
Note 13: All DAC dynamic specifications are valid for a load of 1nF and 10kΩ.
Note 14: Only one digital output (either DOUT, EOC, or the GPIOs) can be indefinitely shorted to either supply at one time.
Note 15: All digital inputs at either V
DVDD
or DGND. V
DVDD
should not exceed V
AVDD
.
Note 16: See the
Reset Register section and Table 9 for details on programming the SLOW bit.
Note 17: Clock mode 11 only.