Datasheet

MAX1070/MAX1071
1.5Msps, Single-Supply, Low-Power,
True-Differential, 10-Bit ADCs
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
DD
= +2.7V to +3.6V, V
L
= V
DD
, V
REF
= 2.048V, f
SCLK
= 24.0MHz, 50% duty cycle, T
A
= -40°C to +85°C, unless otherwise noted.
Typical values are at V
DD
= 3V and T
A
= +25°C.)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V
DD
to GND..............................................................-0.3V to +6V
V
L
to GND ................-0.3V to the lower of (V
DD
+ 0.3V) and +6V
Digital Inputs
to GND .................-0.3V to the lower of (V
DD
+ 0.3V) and +6V
Digital Output
to GND....................-0.3V to the lower of (V
L
+ 0.3V) and +6V
Analog Inputs and
REF to GND..........-0.3V to the lower of (V
DD
+ 0.3V) and +6V
RGND to GND .......................................................-0.3V to +0.3V
Maximum Current into Any Pin............................................50mA
Continuous Power Dissipation (T
A
= +70°C)
12-Pin TQFN (derate 16.9mW/°C above +70°C) ......1349mW
Operating Temperature Range
MAX107_ ETC.................................................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range .............................-60°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
UNITS
DC ACCURACY
Resolution 10 Bits
Relative Accuracy INL (Note 1)
±0.5
LSB
Differential Nonlinearity DNL (Note 2)
±0.5
LSB
Offset Error ±2 LSB
Offset-Error Temperature
Coefficient
±1
ppm/°C
Gain Error Offset nulled ±2 LSB
Gain Temperature Coefficient ±2
ppm/°C
DYNAMIC SPECIFICATIONS (f
IN
= 525kHz sine wave, V
IN
= V
REF
, unless otherwise noted.)
Signal-to-Noise Plus Distortion
SINAD 60 61 dB
Total Harmonic Distortion
THD Up to the 5th harmonic -80 -74 dB
Spurious-Free Dynamic Range SFDR -80 -74 dB
Intermodulation Distortion IMD f
IN1
= 250kHz, f
IN2
= 300kHz -78 dB
Full-Power Bandwidth -3dB point 15
MHz
Full-Linear Bandwidth S/(N + D) > 56dB, single ended 2
MHz
CONVERSION RATE
Minimum Conversion Time t
CONV
(Note 3)
0.667
µs
Maximum Throughput Rate 1.5
Msps
M i ni m um Thr oug hp ut Rate ( N ote 4) 10
ksps
Track-and-Hold Acquisition Time
t
ACQ
(Note 5) 125 ns
Aperture Delay 5ns
Aperture Jitter (Note 6) 30 ps
External Clock Frequency f
SCLK
(Note 7)
24.0
MHz