Datasheet

Typical Operating Characteristics
(V
CC
= +3.3V, V
L
= +0.9V, T
A
= +25°C, MAX13003E.)
0.1
1
10
100
1000
V
L
SUPPLY CURRENT vs. SUPPLY VOLTAGE
(DRIVING I/O V
L
, V
L
= 0.9V)
MAX13000Etoc01
SUPPLY VOLTAGE (V)
V
L
SUPPLY CURRENT (μA)
1.5 2.4 2.71.8 2.1 3.0 3.3 3.6
DATA RATE = 20Mbps
DATA RATE = 230kbps
V
L
SUPPLY CURRENT vs. SUPPLY VOLTAGE
(DRIVING I/O V
CC
, V
L
= 0.9V)
MAX13000Etoc02
SUPPLY VOLTAGE (V)
V
L
SUPPLY CURRENT (mA)
3.33.02.72.42.11.8
0.01
0.1
1
0.001
1.5 3.6
DATA RATE = 20Mbps
DATA RATE = 230kbps
V
CC
SUPPLY CURRENT vs. SUPPLY VOLTAGE
(DRIVING I/O V
L
, V
L
= 0.9V)
MAX13000Etoc03
SUPPLY VOLTAGE (V)
V
CC
SUPPLY CURRENT (mA)
3.33.02.72.42.11.8
0.1
1
10
0.01
1.5 3.6
DATA RATE = 230kbps
DATA RATE = 20Mbps
MAX13000E–MAX13005E
Ultra-Low-Voltage Level Translators
6 _______________________________________________________________________________________
TIMING CHARACTERISTICS (continued)
(V
CC
= +1.5V to +3.6V, V
L
= +0.9V to V
CC
, C
I/OVL
≤ 15pF, C
I/OVCC
≤ 50pF, T
A
= -40°C to +85°C, unless otherwise noted. Typical val-
ues are at T
A
= +25°C.) (Notes 1, 4)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
C
I/OVL
= 50pF, CMOS output, Figure 4 2
Propagation Delay from
I/OV
CC
to I/OV
L
after EN
(Note 5)
t
EN-VL
C
I/OVL
= 50pF, OD output, Figure 4 6
µs
Each translator equally loaded,
MAX13003E/MAX13004E/MAX13005E
±5
Channel-to-Channel Skew t
SKEW
Each translator equally loaded,
MAX13000E/MAX13001E/MAX13002E
±250
ns
Part-to-Part Skew (Note 6) t
PPSKEW
C
I/OVL
= 15pF, C
I/OVCC
= 15pF,
V
L
= +1.8V, V
CC
= +2V, ΔT = +5°C,
MAX13003E/MAX13004E/MAX13005E
10 ns
MAX13003E/MAX13004E/MAX13005E
V
CC
> +1.65V, C
I/OVL
= 50pF,
C
I/OVCC
= 50pF
20 Mbps
Maximum Data Rate
MAX13000E/MAX13001E/MAX13002E
C
I/OVL
= 50pF, C
I/OVCC
= 50pF
230 kbps
Note 1: All devices are 100% production tested at T
A
= +25°C. Limits are guaranteed by design over the entire temperature range.
Note 2: V
L
must be less than or equal to V
CC
during normal operation. However, V
L
can be greater than V
CC
during startup and
shutdown conditions.
Note 3: This consumption is referred to as no signal transmission.
Note 4: Guaranteed by design with an input signal full swing, rise/fall time ≤ 3ns, source resistance is 50Ω.
Note 5: Enable input signal full swing and rise/fall time ≤ 50ns.
Note 6: Guaranteed by design, not production tested.