Datasheet

SHUNT
POSITION
MISO/SDA PIN
CONNECTED TO
OPERATING
MODE
1-2*
SPI/I2C header, pin 6
(MISO)
SPI
2-3
SPI/I2C header, pin 9
(SDA)
I
2
C
Not installed Not connected Not selected
SHUNT POSITION
MOSI/A1 PIN CONNECTED TO OPERATING MODE
JU18 JU14
1-3 Not used
SPI/I2C header, pin 10 (MOSI)
SPI
1-2 Not used +3.3V
I
2
C*
1-5 Not used GND
1-4
1-2
SPI/I2C header, pin 9 (SDA)
2-3
SPI/I2C header, pin 8 (SCL)
Not installed
Not connected Not selected
Not installed Not used
SHUNT POSITION
CS/A0 PIN CONNECTED TO
OPERATING MODE
JU19 JU15
1-3 Not used
SPI/I2C header, pin 5 (CSN)
(with shunt installed on pins 1-2 of JU11)
SPI
1-2 Not used +3.3V
I
2
C*
1-5 Not used GND
1-4
1-2
SPI/I2C header, pin 9 (SDA)
2-3
SPI/I2C header, pin 8 (SCL)
Not installed
Not connected Not selected
Not installed Not used
SHUNT
POSITION
SCLK/SCL PIN
CONNECTED TO
OPERATING
MODE
1-2*
SPI/I2C header, pin 7
(SCLK)
SPI
2-3
SPI/I2C heade, pin 8
(SCL)
I
2
C
Not installed Not connected Not selected
MAX14830 Evaluation Kit
Evaluates: MAX14830
5
MISO/SDA
Jumper JU12 configures the MISO/SDA pin (U1, pin 3)
and routes the signal to the respective headers. See
Table 6 for JU12 shunt positions.
SCLK/SCL
Jumper JU13 configures the SCLK/SCL pin (U1, pin 4)
and routes the signal to the respective headers. See
Table 7 for JU13 shunt positions.
MOSI/A1
Jumpers JU14 and JU18 configure the MOSI/A1 pin
(U1, pin 6). See Table 8 for JU14 and JU18 shunt positions.
CS/A0
Jumpers JU15 and JU19 configure the CS/A0 pin
(U1, pin 5). See Table 9 for JU15 and JU19 shunt positions.
*Default position.
*Refer to the MAX14830 IC data sheet for the corresponding I
2
C slave address.
*Refer to the MAX14830 IC data sheet for the corresponding I
2
C slave address.
*Default position.
Table 6. JU12 Jumper Selection (MISO/SDA)
Table 8. JU14 and JU18 Jumper Selection (MOSI/A1)
Table 9. JU15 and JU19 Jumper Selection (CS/A0)
Table 7. JU13 Jumper Selection (SCLK/SCL)