Datasheet

ManualsBrandsMAXIM INTEGRATED ManualsLinear ICsLinear IC - Op-amp Multi-purpose WLP 6 (1.27x0.87)

General Description

The MAX4464/MAX4470/MAX4471/MAX4472/MAX4474

family of micropower op amps operate from a single

+1.8V to +5.5V supply and draw only 750nA of supply

current. The MAX4470 family feature ground-sensing

inputs and rail-to-rail output. The ultra-low supply cur-

rent, low-operating voltage, and rail-to-rail output capa-

bilities make these operational amplifiers ideal for use

in single lithium ion (Li+), or two-cell NiCd or alkaline

battery systems.

The rail-to-rail output stage of the MAX4464/MAX4470/

MAX4471/MAX4472/MAX4474 amplifiers is capable of

driving the output voltage to within 4mV of the rail with a

100kΩ load, and can sink and source 11mA with a +5V

supply. These amplifiers are available in both fully com-

pensated and decompensated versions. The single

MAX4470, dual MAX4471, and the quad MAX4472 are

unity-gain stable. The single MAX4464 and the dual

MAX4474 are stable for closed-loop gain configurations

of ≥ +5V/V. These amplifiers are available in space-sav-

ing WLP, SC70, SOT23, µMAX

, and TSSOP packages.

Applications

Features

o Ultra-Low 750nA Supply Current Per Amplifier

o Ultra-Low +1.8V Supply Voltage Operation

o Ground-Sensing Input Common-Mode Range

o Outputs Swing Rail-to-Rail

o Outputs Source and Sink 11mA of Load Current

o No Phase Reversal for Overdriven Inputs

o High 120dB Open-Loop Voltage Gain

o Low 500µV Input Offset Voltage

o 9kHz Gain-Bandwidth Product

(MAX4470/MAX4471/MAX4472)

o 40kHz Gain-Bandwidth Product

(MAX4464/MAX4474)

o 250pF (min) Capacitive Load Capability

o Available in Tiny, 6-Bump WLP, 5-Pin SC70, and

8-Pin SOT23 Packages

MAX4464/MAX4470/MAX4471/MAX4472/MAX4474

Single/Dual/Quad, +1.8V/750nA, SC70,

Rail-to-Rail Op Amps

________________________________________________________________

Maxim Integrated Products

MAX4470

WLP BUMP

SIDE DOWN

OUT N.C.

IN- V

IN+ V

C1 C2

B1 B2

A2A1

Pin Configurations

PART

NO. OF

AMPLIFIERS

GAIN-

BANDWIDTH

MINIMUM

STABLE GAIN

MAX4464

1 40kHz 5V/V

MAX4470

1 9kHz 1V/V

MAX4471

2 9kHz 1V/V

MAX4472

4 9kHz 1V/V

MAX4474

2 40kHz 5V/V

19-2021; Rev 4; 7/11

Ordering Information

µMAX is a registered trademark of Maxim Integrated Products, Inc.

PART

TEMP

RANGE

PIN-

PACKAGE

TOP

MARK

MAX4464EXK+T -40°C to +85°C 5 SC70 +ABT

MAX4464EUK+T -40°C to +85°C 5 SOT23 +ADPI

MAX4470EXK+T -40°C to +85°C 5 SC70 +ABS

MAX4470EUK+T -40°C to +85°C 5 SOT23 +ADPH

MAX4470EWT+ -40°C to +85°C 6 WLP +BP

MAX4471EKA+T -40°C to +85°C 8 SOT23 +AAEK

MAX4471ESA+ -40°C to +85°C 8 SO —

MAX4472EUD+ -40°C to +85°C 14 TSSOP —

MAX4472ESD+ -40°C to +85°C 14 SO —

MAX4474EKA+T -40°C to +85°C 8 SOT23 +AAEL

MAX4474EUA+ -40°C to +85°C 8 µMAX —

MAX4474ESA+

-40°C to +85°C

8 SO —

Pin Configurations continued at end of data sheet.

Selector Guide

Battery-Powered

Systems

Portable Instrumentation

Pagers and Cellphones

Micropower

Thermostats

Electrometer Amplifiers

Solar-Powered Systems

Remote Sensor Active

Badges

pH Meters

For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,

or visit Maxim’s website at www.maxim-ic.com.

Denotes a lead(Pb)-free/RoHS-compliant package.

Summary of content (19 pages)

PAGE 1
9-2021; Rev 4; 7/11 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Features o o o o o o o Ultra-Low 750nA Supply Current Per Amplifier Ultra-Low +1.
PAGE 2
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps ABSOLUTE MAXIMUM RATINGS VDD to VSS ...............................................................-0.3V to +6V IN_+ or IN_-......................................(VSS - 0.3V) to (VDD + 0.3V) OUT_ Shorted to VSS or VDD ......................................Continuous Continuous Power Dissipation (TA = +70°C) 5-Pin SC70 (derate 3.1mW/°C above +70°C)...................247mW 5-Pin SOT23 (derate 7.
PAGE 3
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps (VDD = +5V, VSS = 0V, VCM = 0V, VOUT = VDD/2, RL = ∞ to VDD/2, TA = +25°C, unless otherwise noted.
PAGE 4
Typical Operating Characteristics (VDD = +5V, VSS = 0V, VCM = 0V, RL = 100kΩ to VDD/2, TA = +25°C, unless otherwise noted.) 0.6 0.5 0.4 0.3 0.6 0.5 0.4 0.3 0.40 0.35 0.30 0.25 0.20 0.15 0.2 0.10 0.1 0.1 0.05 0 0 0 -50 -25 0 25 50 75 -50 100 -25 0 25 50 75 SUPPLY VOLTAGE (V) TEMPERATURE (°C) TEMPERATURE (°C) OFFSET VOLTAGE vs. COMMON-MODE VOLTAGE INPUT BIAS CURRENT vs. TEMPERATURE INPUT BIAS CURRENT vs. COMMON-MODE VOLTAGE 0.35 0.30 0.25 0.20 0.15 0.
PAGE 5
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps -70 -80 -90 -100 0.8 0.6 0 25 50 75 70 60 -50 100 -25 0 CL = 12pF RL = 1MΩ AVCL = 1000V/V GAIN 180 135 0 GAIN (dB) 90 45 -45 PHASE -90 10 100 1k 50 75 2.5 100 10k -135 100k 5.0 0 -80 -100 -45 PHASE -120 RL = 1MΩ AVCL = 1000V/V CL = 250pF -90 100 1k 10k -140 -135 100k 10 100 1k 10k 100k FREQUENCY (Hz) FREQUENCY (Hz) FREQUENCY (Hz) MAX4470/MAX4471/MAX4472 TOTAL HARMONIC DISTORTION PLUS NOISE vs.
PAGE 6
Typical Operating Characteristics (continued) (VDD = +5V, VSS = 0V, VCM = 0V, RL = 100kΩ to VDD/2, TA = +25°C, unless otherwise noted.) MAX4470/MAX4471/MAX4472 SMALL-SIGNAL STEP RESPONSE IOUT vs.
PAGE 7
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps -3 -2 -3 -3 -4 -5 -5 -5 -6 -6 -6 -7 -7 10k 1k 100 10k 1k 10k FREQUENCY (Hz) MAX4470/MAX4471/MAX4472 LARGE-SIGNAL GAIN vs. FREQUENCY MAX4464/MAX4474 GAIN AND PHASE vs. FREQUENCY MAX4464/MAX4474 GAIN AND PHASE vs.
PAGE 8
Typical Operating Characteristics (continued) (VDD = +5V, VSS = 0V, VCM = 0V, RL = 100kΩ to VDD/2, TA = +25°C, unless otherwise noted.) INPUT 10mV/div INPUT 100mV/div OUTPUT 500mV/div OUTPUT 50mV/div OUTPUT 50mV/div VDD = +5V AV = +5V/V RL = 1MΩ CL = 8pF 500µs/div 500µs/div 500µs/div MAX4464/MAX4474 PERCENT OVERSHOOT vs.
PAGE 9
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps MAX4464/MAX4474 SMALL-SIGNAL NORMALIZED GAIN vs. FREQUENCY 1 1 -2 -3 -3 -4 -5 -6 -6 -7 100 1k 10k 100k 1k 10k MAX4464/MAX4474 LARGE-SIGNAL NORMALIZED GAIN vs. FREQUENCY MAX4464/MAX4474 LARGE-SIGNAL NORMALIZED GAIN vs.
PAGE 10
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.
PAGE 11
Single/Dual/Quad, +1.
PAGE 12
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Package Information For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status. 12 PACKAGE TYPE PACKAGE CODE DOCUMENT NO. LAND PATTERN NO.
PAGE 13
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 14
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Package Information (continued) For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 15
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 16
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Package Information (continued) For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 17
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 18
MAX4464/MAX4470/MAX4471/MAX4472/MAX4474 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Package Information (continued) For the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status.
PAGE 19
Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps REVISION NUMBER REVISION DATE 3 6/10 Added WLP package 4 7/11 Updated power-on time specification DESCRIPTION PAGES CHANGED 1, 2, 9, 10, 11 3 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.