Datasheet
DESIGNATION QTY DESCRIPTION
C1 1
10FF Q10%, 10V X5R ceramic
capacitor (0603)
TDK C2012X5R1A106K/1.25
C2 1
1FF Q10%, 10V X7R ceramic
capacitor (0603)
TDK C1608X7R1A105K
C3, C4, C5 3
0.1FF Q10%, 16V X7R ceramic
capacitors (0603)
Murata GRM188R71C104KA01D
F1 1
4.7FF EMI filter (3-terminal
capacitor)
Murata NFM21PC475B1A3D
J1 1 6-pin right-angle male header
DESIGNATION QTY DESCRIPTION
J2 1 4-pin straight male header
JP1 1 3-pin straight male header
R1, R2, R3 3
150I Q5% resistors (0603)
R4 1
4.7kI Q5% resistor (0603)
U1 1
16-bit buffered single DAC
(8 FMAX
M
)
Maxim MAX5216GUA+
U2 1
Ultra-precision series voltage
reference (5 SOT23)
Maxim MAX6029EUK25+
— 1 Shorting jumper
— 1 PCB: EPCB5216PM1
PIN SIGNAL DESCRIPTION
1
SS
Chip enable. Assert low to enable the
SPI interface.
2 MOSI MAX5216 serial-data input
3 N.C. Not connected
4 SCK MAX5216 serial-clock input
5 GND Ground
6 VCC Power supply
PIN SIGNAL DESCRIPTION
1 DACOUT Buffered DAC output
2
CLR
Active-low asynchronous digital-clear
input. Drive low to clear contents of the
DAC registers and set the DAC output
to zero.
3 VREFIN DAC reference voltage input
4 GND Ground
SUPPLIER PHONE WEBSITE
Murata Electronics North America, Inc. 770-436-1300 www.murata-northamerica.com
TDK Corp. 847-803-6100 www.component.tdk.com
_________________________________________________________________ Maxim Integrated Products 2
MAX5216PMB1 Peripheral Module
Detailed Description
SPI Interface
The MAX5216PMB1 peripheral module can plug directly
into a Pmod-compatible port (configured for SPI) through
connector J1. For information on the SPI protocol, refer to
the MAX5214/MAX5216 IC data sheet.
J1 provides connection of the module to the Pmod host.
See Table 1.
Connector J2 provides connection to the IC pins.
Jumper JP1 allows the user to select between reference
voltages for the DAC IC (see Table 3).
Reference Voltage
The MAX5216PMB1 peripheral module contains a
MAX6029 precision voltage reference for the REF input
of the IC. The MAX6029 outputs a 2.5V reference.
Software and FPGA code
Example software and drivers are available that execute
directly without modification on several FPGA devel-
opment boards that support an integrated or synthe-
sized microprocessor. These boards include the Digilent
Component List
Component Suppliers
Note: Indicate that you are using the MAX5216PMB1 when contacting these component suppliers.
µMAX is a registered trademark of Maxim Integrated Products,
Inc.
Table 1. Connector J1 (2-Wire
Communication)
Table 2. Connector J2