Datasheet

MAX5318 Evaluation System
Evaluates: MAX5318
5Maxim Integrated
14) Observe that the DAC outputs a sine wave of 1kHz,
amplitude range is 0 to 4.096V.
15) Connect the USB cable from the PC to the
MAXUSB2XILINX board. A Windows message
appears when connecting the MAXUSB2XILINX
board to the PC for the first time. Each version of
Windows has a slightly different message. If you
see a Windows message stating ready to use, then
proceed to the next step. Otherwise, open the USB_
Driver_Help_200.PDF document in the Windows
Start | Programs menu to verify that the USB driver
was installed successfully.
16) Start the EV kit software by opening its icon in
the Windows Start | Programs menu. The EV
kit software main window appears, as shown in
Figure 2. Within 5s, the software should auto-
matically connect to the hardware; verify that
MAX5318EVKIT Hardware Connected appears in
the bottom-left status bar.
17) Observe that the IC’s OUT waveform is a 1kHz
sine wave.
18) Drag the Frequency track bar up and observe that
the output frequency increases.
Figure 1. MAX5318 EV Kit Jumper Locations
Figure 2. MAX5318 EV Kit Software Main Window (Block Diagram Tab)