Datasheet

MAXQ610
16-Bit Microcontroller with Infrared Module
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 29
© 2011 Maxim Integrated Products Maxim is a registered trademark of Maxim Integrated Products, Inc.
Revision History
REVISION
NUMBER
REVISION
DATE
DESCRIPTION
PAGES
CHANGED
0 10/08 Initial release —
Removed the Sysclk = 1MHz condition for the Active Current parameter, changed
the R
PU
min values from 18k and 19k to 16k and 17k, and changed the f
NANO
T
A
= +25°C min and max values from 4.2kHz and 14.0kHz to 3.0kHz and 20.0kHz,
respectively, in the Recommended DC Operating Conditions table
4, 5
1 11/08
Added the sentence “Software must configure this pin after release from reset to
remove the high-impedance input condition.” to the IRRX, P0.x, P1.x, P2.x, and P3.x
descriptions in the Pin Description table
8, 9
Added future status to the 32 TQFN package in the Ordering Information table 1
2 1/09
Changed the REGOUT pin series resistance from 1 to 2 to 10 in the Pin
Description table
8
Changed the t
IRRX_A
minimum spec from 200ns to 300ns in the Recommended DC
Operating Conditions table
5
3 7/09
Removed the statement about the use of multilayer boards from the Grounds and
Bypassing section
25
4 10/09
Adjusted the minimum resonator frequency from DCMHz to 1MHz and the minimum
programming frequency from 5MHz to 6MHz in the Recommended DC Operating
Conditions table
5, 6
5 2/10 Added the 44-pin TQFN package
1, 8, 9, 10, 26,
27, 28
6 7/11
Removed future status from the MAXQ610A-0000+ in the Ordering Information table;
added the continuous power dissipation, lead temperature, and soldering
temperature information to the Absolute Maximum Ratings section
1, 4