Datasheet

Download, read, and carefully follow each step in the appropriate Petaluma (MAXREFDES30#) ZedBoard Quick Start Guide.
Lab Measurements
Equipment used:
Audio Precision
®
SYS-2722 signal source or equivalent
Voltage calibrator DVC-8500
Windows PC with two USB ports
Petaluma (MAXREFDES30#) board
ZedBoard kit
Take special care and use proper equipment when testing the Petaluma design. Duplication of the presented test data requires a
signal source with higher accuracy than the design being tested. A low distortion signal source is absolutely required to duplicate
the presented results. The input signal was generated using the Audio Precision SYS-2722. The FFTs were created using the FFT
control in SignalLab from Mitov Software.
Figure 4. AC FFT for channel 7 (AIN7) using on-board power, a -10V to +10V, 10kHz sine wave input signal, a 250ksps sample
rate, and a Blackman-Harris window at room temperature.
Page 7 of 10