Assembly Instruction

4
4. HANGING THE FAN
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly. NOTE:
This ceiling fan is supplied with two types of
hanging assemblies; the standard ceiling
installation using the downrod with ball and
socket mounting and the "close-to-ceiling"
installation. The "close-to-ceiling" installation is
recommended in rooms with less than 8-feet
ceilings or in areas where additional space is
desired from the floor to the fan blades.
STANDARD CEILING INSTAL
LATION
Step 1. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket
as shown in Fig.5.
Step 2. Secure the hanger bracket to the
ceiling outlet box with the screws and washers
provided with your outlet box.
Step 3. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly.
Step 4. Route wires exiting from the top of the
fan motor through the canopy and then
through the ball/downrod. (Fig.6)
Step 5. Align the holes at the bottom of the
downrod with the holes in the collar on top of
t
he motor housing. Carefully insert the hitch
pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end of
the hitch pin until it snaps into its
locked position. (Fig.6)
Step 6. Tighten two set screws on top of the
fan motor firmly.
Step 7. Place the downrod ball into the hanger
bracket socket. This will allow you to
make the electrical connections. (Fig.7)
Mounting screws
(supplied with
electrical box)
Hook
Ceiling
mounting
plate
UL Listed
electrial
box
Fig.5
Fig.6
120V Wires
Washers
Downrod
Canopy
Set screws
Hitch pin
Lock pin
Fig.7
Registration slot