Datasheet
PCN # 1361
DATE: November 14, 2013
Quality Assurance
160 Rio Robles
San Jose, CA 95134
PROCESS CHANGE NOTICE
X PRODUCT CHANGE NOTICE
MAXIM HEREBY ISSUES NOTIFICATION OF CHANGE
THAT MAY AFFECT THE FOLLOWING CATEGORIES:
X DESIGN X WAFER FAB ASSEMBLY TEST X ELEC/MECH SPECS
AFFECTED PRODUCT:
Ordering P/N: (See PN listing XLS in PCN ZIP file)
CHANGE FROM: DS1624 current die revision A7.
Fabricated at Maxim’s Dallas facility; closed in 2010.
CHANGE TO: DS1624 die revision B2
Fabricated at Maxim’s San Antonio (SA) using the E35 process.
A design architecture change was implemented resulting in
changes to the datasheet. See attached table.
JUSTIFICATION: The fab process used to build the DS1624 A7 revision was discontinued with the closing of the Dallas fab. The
transfer to Maxim’s San Antonio fab process required a redesign, DS1624 B2, resulting in the following datasheet changes.
TRACEABILITY: MAXIM maintains traceable by markings as branded on packaged units.
Maxim's Change Notification System is designed to keep our customer base appraised of major product, manufacturing, or facility
improvements.
Deborah Meeker / PCN Coordinator
For further information, please contact either of the people listed below.
Contact your local Maxim Company Representative or Deborah Meeker, PCN Coordinator
408-601-5618 / pcn.coordinator@maxim-ic.com
Document Title: Product Change Notice - Notification Only Document ID: 18-0582/J