T 2 Contemporary Lighting™ PRODUCT NAME:Mermaid 1LT Pendant ITEM NUMBER: E21441 Please consult your electrician for hanging fixture and wiring. ‘The fixture is designed to dim with a standard Traci forward phase dimmer. Dimming levels will vary by dimmer. Below is a list of recommended dimmers: Lu tron MA CL-153M Lu tron DVL153P Lu tron SCLA153P Levi ton [PLO6-10Z Levi ton 6674-POW Dus to inrush current wattage should ot exceed 150 watts of product for a 600 watt dimmer.
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation ¥ Bracket (A) Screws(B) Mounting Screws(C) Canopy(D) Locate all hardware & components before discarding packaging o (C)—E ! 4 Ste pl :Remove mounting bracket from fixture and install to electrical box. 1) 2. Step :Adjust wire length to desired mounting height, and tighten strain relief screws to secure. Wire fixture to wires in outlet box. Green wire is for Ground.
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation pa — . Slanting Golden Acrylic(G) Striped nut(H) lampshade lampshade (B) Locate all hardware & components before discarding packaging — B 4) [15) I © | s00 Step :Fit lampshade(F) into with acrylic(G) and tighten center locking nut(H). Cleaning & Care: Clean with soft cloth and a mild detergent. Do not use abrasive cleaner.
Pendant Wires Driver Wires Pendant | Driver Underwire Red Outer Mesh Driver Black(-) Step 5.If wires are cut in the process of adjusting the height, please note the pendants consist of an outer mesh wire(Negative) and inner (Positive ) wire that must be separated before re-joining with the driver output wires. Pendants are wired in series to the driver, as shown below.
