Installation Sheet

Installation Instructions

Model E22779-91PC

41 3

2 5

1.Turn breaker off for circuit on outlet

where fixture is to be installed.

2.Remove mounting bracket from fixture

and install to electrical box. (Figure 1)

3.Position back-plate onto mounting

bracket and mark 3 holes onto ceiling for

hollow wall anchors.

4.Remove back-plate from mounting

bracket.

5.Drill 3 x 1/8” holes and insert hollow

wall anchors.

6.Reinstall back-plate and secure to ceiling

using 3 screws included into hollow wall

anchors.

7.Wire fixture to wires in outlet box.

Green wire is for Ground.

8.Install fixture to back-plate and tighten 4

nuts so that fixture meets the ceiling.

(Figure 4)

9.Remove protective paper from fixture.

(Figure 3)

10.Install glass into holders using 2 screws

supplied (Figure 5)

WARNING!

This fixture may be dimmed using

standard triac dimmer.For maximum

adjustability We recommend Lutron

CL series dimmers.

PAGE 1
Installation Instructions Model E22779-91PC 1 3 2 5 4 1.Turn breaker off for circuit on outlet where fixture is to be installed. 2.Remove mounting bracket from fixture and install to electrical box. (Figure 1) 3.Position back-plate onto mounting bracket and mark 3 holes onto ceiling for hollow wall anchors. 4.Remove back-plate from mounting bracket. 5.Drill 3 x 1/8” holes and insert hollow wall anchors. 6.Reinstall back-plate and secure to ceiling using 3 screws included into hollow wall anchors. 7.