User's Manual

Maximum Wireless
Installation Instructions
Cont.
Wind Transmitter
Insert the two enclosed AA Ni-Cad batteries into the enclosed
battery charger (be sure to observe Polarity) and charge batteries
for 12 hours. (Do not attempt to charge any batteries other than NI-Cad
batteries. This could cause the batteries to explode, possibly causing
physical damage or fire).
Connect the sensors to the Wind Transmitter wire.
Feed the terminal lug end of the Yellow and Brown wires through
one of the rubber boots and connect the lugs to the terminals on
the bottom of the wind speed sensor using the brass nuts provided.
The polarity does not matter. (DO NOT adjust the nuts that are
already on the sensor).
Feed the terminal lug ends of the wind direction sensor through the
other rubber boot. Wire the wind direction sensor as follows:
1=White, 2=Orange, 3=Black, 4=Red, 5=Green
Use the Hex nuts provided. (Do NOT adjust the nuts that are
already on the wind direction sensor).
Slide the stub mast through the rubber boots and insert the stub
masts into the bottom of the sensors. Secure with the cotter pins.
When connecting the Wind Direction sensor to the Z-mast, make certain
that the #3 terminal is aligned with the Z-mast arm. If the sensor is not
installed in this manner your wind direction readings will be incorrect.
Remove the bottom half of the clamp on the back of the Wind
transmitter by loosening the screws.
Place the Transmitter on the Wind Direction mast with the antenna
above the mast arm.
Place bottom of the clamp in back of the mast and secure with the
screws that were removed.
Secure the sensors and stub masts to your antenna mast (not
supplied) with the two hose clamps.
Open the Wind Transmitter box by lifting the latches on the box.
Place the Jumper to the Test position. (See Diagram)
The test position will ensure that the receiver is polling each
individual sensor.
Temperature Transmitter
The Temperature sensor operates on two AA Alkaline batteries
(enclosed). Do not connect the batteries yet.
Open the Temperature Transmitter box by lifting the latch on the
box.
Place the Jumper on the Test position. (See Diagram)
Rainfall Transmitter
The Rainfall sensor operates on two AA Alkaline batteries
(enclosed). Do not connect the batteries yet.