User Manual

A. Receivers (cont.)
2. Rainwatch
- Connect the Yellow wire from the receiver to terminal #4 of the Rainwatch.
- Connect the Brown wire from the receiver to terminal #5 of the Rainwatch.
B. Transmitters
1. Temperature
- The Temperature transmitter operates on two AA Alkaline batteries (supplied).
o Do Not install the batteries yet.
- Open the thumb-latch on the Temperature transmitter case, and place the
circuit board Jumper in the test position (see Diagram A). This will ensure that
the Receiver recognizes the Temperature transmitter when batteries are
eventually installed.
Jumper
Normal Position
Test Position
Diagram A
2. Rain Transmitter
- The Rainfall transmitter operates on two AA Alkaline batteries (supplied).
o Do Not install the batteries yet.
- Remove the top of the Rain Collector by loosening the four Phillips head
screws and rotating the top counter-clockwise.
- Remove the blue cover to access the circuit board, and place the circuit board
Jumper in the test position (see Diagram B). This will ensure that the Receiver
recognizes the Rainfall transmitter when batteries are eventually installed.