User Manual

3. Wind Transmitter (cont.)
- Remove the bottom portion of the black bracket on the back of the Wind
transmitter case, by loosening the four black screws.
- Place the Wind transmitter case on the horizontal section of the formed wind
direction mast with the antenna situated above the mast arm.
- Place the bottom portion of the black bracket behind the mast arm and secure
it in place with the four black screws that were removed.
- Secure both sensor stub masts to your antenna mast (not supplied) with the
two hose clamps provided.
- Open the Wind transmitter case by lifting the two thumb latches, and place the
circuit board Jumper in the test position (see Diagram C). This will ensure that
the Receiver recognizes the Wind transmitter when batteries are eventually
inserted.
Jumper
Normal Position
Test Position
Diagram C
IV. Transceiver Testing & Sensor Installation (please follow directions in the order shown)
A. Instrument Display
- Move the instrument display and the individual sensors nearby the desired
installation location (the display may lie on a table or floor for testing purposes).
o This step is necessary to determine whether or not proper signals can
be obtained for each component, prior to final installation.
- Connect the AC adaptor(s) provided, to the instrument(s).
o If you have more than 1 instrument, wire 1 AC adaptor to each
instrument.
- Plug in all the AC adaptors.
SOLDER SIDE