User Manual

Insert a strip of nails into the magazine.
Ensure the points of the nails are facing
down. Be sure to insert the heads of the
nails into the channel. Release pusher (1)
to push nails forward until it comes to the
end. The tool is now ready for use (Fig. E).
(See nail type icon on page 14.)
Operation Mode
WARNING!
Potential hazard that could result in serious injury
or loss of life.
• Always know the operational mode of the nailer before
using it. Failure to comply could lead to serious injury
or loss of life.
3.
4.
5.
1716
model no. 058-9844-2 | contact us 1-888-670-6682
WARNING!
Potential hazard that could result in serious
injury or loss of life.
•
•
•
Plug in compressor, turn it on and set the
pressure regulator to 90 PSI (6.2 bar).
Attach one end of the air hose to the
compressor and the other end of the air
hose (1) to the tool (2) (Fig. F).
Test
the workpiece. If the nails are being driven too deep or not deep enough,
adjust the regulator in order to provide higher or lower air pressure, or
use the depth-of-drive adjustment to achieve desired nail penetration.
the driving depth using a sample piece of wood before working on
Do not operate the tool if the nails are not loaded, doing
so may damage the tool.
Do not fire nails into the air, doing so may cause injury to
the operators or others, apart from damaging the tool.
Load the correct type of nails only and do not load
different sized nails into the magazine, as doing so may
cause nails to jam. Failure to comply could lead to
serious injury or loss of life.
1
2
Fi
Fig. G
g. E
2
Fig. F
R
1
(Refer to the wood density chart on
page 12.)
This framing nailer offers two types of actuation modes.
Sequential actuation mode
1. Press the safety tip firmly against the workpiece.
2. Pull the trigger.
3. If the safety tip remains pressed, successive nails will fire each time the
trigger is pulled.
Contact fire (Bump fire) actuation mode
Using this mode, two methods are available: single fastener placement
and rapid fastener operation.
SINGLE FASTENER PLACEMENT:
1. Press the safety tip firmly against the workpiece.
2. Pull the trigger.
RAPID FASTENER OPERATION:
1. Pull the trigger.
2. Knock the safety tip onto the workpiece. As long as the trigger is pulled,
the tool will drive a nail every time the contact tip is depressed.
This nailer is on sequential fire mode when toggle switch tail is upward and
can switch to bump fire mode with toggle switch tail downward (Fig. G).
Mode Conversion
• Hold the gun properly and be mindful of the kick-back
after each nail shot. Failure to comply will lead to serious
injury or loss of life.