Instruction Manual

18” WALL MOUNT

INSTALLATION

30 Samuel Barnet Blvd.

New Bedford, MA 02745

(508) 995-2200

Page 1

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,

ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,

OR HARDWARE STORE FOR REFERRALS).

Slip the swaged end of mast A into the

round end of mast B.

WOOD BLOCK

SWAGED END

Tap the two sections together with a hammer.

A piece of wood will protect the end from

damage.

MAST B

MAST A

MAST B

MAST A

Bolt two half-sections together to make one

complete top bracket assembly

7/16”

HAMMER

TAPE MEASURE

7/16” WRENCH

3/8”

3/8” WRENCH

TOOLS

REQUIRED

DRILL WITH

1/8” DRILL BIT

PHILLIPS SCREW

DRIVER

LEVEL

CLAMPING

SCREWS

LAG

SCREW

SWAGED END

SUPPORT

LEG

SLOTTED SCREW

DRIVER

TOP BRACKET ASSEMBLY

PAGE 1
8” WALL MOUNT INSTALLATION PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE FOR REFERRALS).
PAGE 2
18” WALL MOUNT INSTALLATION A B Must be positioned so that leg will utilize hole “B” Must be oriented so that flanged end will be flush against the wall. 3b Bolt the remaining two half-sections together with the support leg between to make one complete bottom bracket assembly. The support leg must be secured utilizing hole “B” and oriented so that the bent flange will be flush against the wall.
PAGE 3
18” WALL MOUNT INSTALLATION 6 Secure the brackets with the lag screws ROOF PEAK ROOF PEAK LAG SCREWS 18 INCH BRACKET CLAMPING SCREWS 7 Hold the lower bracket, support leg combination so that it is level. Drill a 1/8” pilot hold and secure the lower end of the support leg with a lag screw. MAST LEVEL 8 Slip mast into brackets and secure with the clamping screws. LEG SCREW 30 Samuel Barnet Blvd.