Use and Care Guide

A
B
C
2
PACKAGE CONTENTS
Part Description Quantity
A
B
C
Fixture
Wire Nut
Screw
1
3
2
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and
operation of the product and the hazards involved.
•Riskoffireorelectricshock. LED ceiling fixtureinstallationrequiresknowledgeofluminarieselectricalsystems.Ifnotqualified,do
notattemptinstallation. Contactaqualifiedelectrician.
• Disconnect power at fuse or circuit breaker before installing or servicing.
• No user serviceable parts inside. To avoid electrical shock, do not disassemble product.
• This device is not intended for use with emergency exits. Not for use where exposed directly to the weather or water.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Donotmakeoralteranyopenholesinanenclosureofwiringorelectricalcomponentsduringinstallation.
• Installers should not disconnect existing wires from lampholder terminals to make new connections at lampholder terminals.
Instead, installers should cut existing lampholder leads away from the lampholder and make new electrical connections to
lampholder leads by employing applicable connectors.
• Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user'sauthority
to operate the equipment.
• Ground the fixture to avoid potential electric shocks and to ensure reliable starting.
• Double-check all connections to be sure they are tight and correct.
• Some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION
• Turn power off before inspection, installation or removal.
• Use only on 120 V AC, 60 Hz circuits.
NOTE
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.