CATALOG 2nd Edition
DRAFT 09.18.2013 Service and installation must be performed by a trained/experienced service technician. All products used with combustible gas must be installed and used strictly in accordance with the instructions of the Original Equipment Manufacturer (OEM) and with all applicable government codes and regulations, e.g. plumbing, mechanical, and electrical codes and practices. Maxitrol products should be installed and operated in accordance with Maxitrol Safety Warning Instructions.
DRAFT 09.18.2013 ACCESSORIES Vent Tube Connector Threaded sleeve - two piece assembly where the nut is tightened inside male connector. • 11A03: connects 1/8” female pipe thread to 1/8” O.D. tubing. • 11A04: connects 1/8” female pipe thread to 1/4” O.D. tubing. Threaded sleeve nut - for RV20V. • 11A08: 5/16-24 threaded sleeve nut for 1/8” O.D. tubing. Compression fitting - where nut and sleeve are slipped over tubing and tightened into fitting body.
DRAFT 09.18.2013 ACCESSORIES ® C Vent Protector: US ® Designed for outdoor applications. Use on vent opening to protect breather hole from rain, snow, dust, insects and other foreign particles. NOTE: Vent protector MUST be mounted in an upright position. • 13A15: for 1/8” NPT vent. For outdoor use in 325-3, 325-3L, RV48, RV52, RV53, RV61, R500(S)(Z), and R600(S)(Z). • 13A15-5: for 3/8” NPT vent. For outdoor use in 325-5, 325-5L, RV81, 210D. • 13A25: for 1/2” NPT vent.
DRAFT 09.18.2013 CHOOSING A VENT ACCESSORY NOTE: If vent limiting device is not used, regulator vent must be piped in accordance with government and local codes and regulations. RV12L, RV20L Integral vent limiting orifice with dust cap standard. RV20VL Integral vent limiting orifice with dust cap standard or use 11A08 threaded sleeve nut and run vent line as per code.
Maxitrol Company 23555 Telegraph Rd., PO Box 2230 Southfield, MI 48037-2230 GPR_MS_EN_10.2015 www.maxitrol.