User's Manual

3736
2. Why PIR Motion detector does not detect movement?
A. Please make sure the control panel is in arming status, not at stay
(home)mode or disarming status.
B. Please make sure the LED of PIR motion detector lights up when you
walk in the detection area.
C. Movement should cross the detection and within 8 meters range.
D. The detector enters sleeping mode to save power after first detection. If
there's no movement within 4 minutes, the detector goes back to the
working state. If there's detection occurs within 4 minutes, the time detector
goes back to working state will be added accordingly.
E. Make sure the insider battery contact well or not.
F. Check the board put well or not.
G. If zone jumper is changed, please enroll the sensor to the system again.
3. If the PIR motion detector pet-immunity?
No. The PIR supplied in standard kit is normal PIR. If you have pets at home,
please adjust the installing height to allow your pets to roam below the
mounting height of the unit without causing alarms.
4. There’s no one passerby the room, but the detector trigger the alarm
A. Check if there's any pet at home, the PIR supplied in the standard kit is
normal one, not pet-immune one.
B. Please avoid mounting the P.I.R. motion detector at the place where
rapid heat changes such as window, air conditioner, light, electric heater,
refrigerator, oven, stove etc.
C. Avoid strong sunlight.
D. The installation height and range should be in the detection area.
1. Why PIR Motion Detector beeps without detecting intruders?
If PIR Motion Detector beeps, and LED indicator flashes continuously,
the detector is in low battery. Please change the battery immediately.
PIR Motion Detector
It’s 100 meters in open area. The walls might shorten the distance, it’s
recommended to install the accessories at the right place, and move
the panel to adjust a better signal receiving. If the house is too large,
it’s better to add a signal repeater to boost the coverage.
1 . This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
2
. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
FCC STATEMENT