User's Manual

76
A. Pull out insulating strip.
B. Arm the system with “ ” button.
C. Now separate both parts of the sensor and hold
them at least 5cm away from one another.
A red light will briefly flash on the sensor
3. Using and Testing the Door Sensor
2. Using and Testing the Remote Control(s)
A. Press the panic button“ ”. A small display
on the remote control will briefly light up.
A loud alarm tone will immediately sound and
the symbol on the control panel will flash red .
Turn the alarm off again by pressing the B.
disarm “ ” button.
Congratulations!
Your remote control( s ) are working!
D. As soon as the alarm sounds, disarm the control
panel with “ ”on the remote control.
Congratulations.
The door sensor is now working!
A. Carefully open the cover of the motion sensor
by pressing the clip and pull out insulating strip.
B. Fix the cover by the short screw.
D. Now press the small, black button (program) on
the rear of the motion sensor.
4. Using and Testing the Motion Detector
C. Arm the system with “ ” button.
E. As soon as the alarm sounds, disarm the control
panel with “ ” on the remote control
Congratulations.
The motion sensor is now working!