Owner's Manual

LOW VOLTAGE LIGHTBARS INSTALLATION INSTRUCTIONS
WARNING
• RISK OF ELECTRIC SHOCK – Disconnect the power at fuse or circuit breaker before installing or servicing.
• The use of other manufacturer’s components will void the warranty and listing of this product.
• This product must be wired in accordance with all national and municipal codes.
• This product should be installed by a qualified electrician.
• Suitable for damp locations.
• Be sure to follow the instructions in the order given.
• Save these instructions.
© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 1
REV: 01/13/16
MOUNTING OPTIONS:
Step 1: How to mount Lightbars
There are three ways to mount the Low Voltage Lightbars using different accessories.
1.) Install with fixing clips.
a.) Make sure the clips to be installed in a
line in a proper distance between each one.
b.) Using the screws to fix the clips. c.) Install the Lightbars into the clips.
2.) Install with 3M adhesives.
a.) Stick the 3M adhesive on the back of the
Lightbars in a proper distance between
each one
b.) Paste the Lightbars on the place
to be installed.
c.) Paste the Lightbars on the place to be
installed.
3.) Install with 3M + Magnet plate & 3M + Iron plate.
a.) Stick the magnets on the back of the
Lightbars with 3M adhesive in a proper
distance between each one.
b.) Put the iron on the magnet. c.) Paste the Lightbar on the place to be
installed.