Installation Instructions

Operating Instructions LED PL Retrofit Lamps - 6W & 8W
MaxLite LED PL Retrofit Lamps
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 1
REV: 2/06/17
®
General Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION
WARNING – Risk of fire or electric shock. LED Retrofit Kit installation
requires knowledge of luminaires electrical systems. If not qualified, do not
attempt installation. Product must be installed in accordance with the
National Electrical Code or your local electrical code. If you are not
familiar with these codes and requirements, contact a qualified electrician.
Picture is for illustration
purposes only. Your model
may vary.
WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that have the construction
features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit
kit does not exceed the input rating of the luminaire.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or any other
sharp objects.
WARNING – Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when
installing of retrofit kit hardware. Check for enclosed wiring and components.
WARNING – Risk of fire or electric shock. Check the existing wiring for damage before installing upgrade kit.
Do not install if existing wires are damaged.
Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp
holder terminals. Instead installers should cut existing lamp holder leads away from the lamp holder and make
new electrical connections to lamp holder lead wire by employing applicable connectors.
"This luminaire has been modified and can no longer operate the originally intended lamp," shall be marked on
the retrofit luminaire where readily visible by the user during normal maintenance including lamping.
DO NOT USE WITH DIMMERS. SUITABLE FOR DAMP LOCATIONS.
SUITABLE FOR USE IN TOTALLY ENCLOSED, RECESSED LUMINAIRES.
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS.
This product is intended to retrofit Type IC or non-IC recessed mount Listed luminaires with instructions to
remove the existing trim. The minimum dimensions of luminaries are tabulated below.