Owners Manual

ManualsBrandsMaxLite ManualsShop All MaxLiteMaxLite Linear High Bay Single Light 23-13/16" Wide 135 Watt Integrated LED High Bay - 4000K - Bi-Level Motion Sensor

Operating Instructions BLHE Series

MaxLite BayMax Linear High Bay Eco Series

• To reduce the risk of death, personal injury or property damage from fire,

electric shock, falling parts, cuts/abrasions, and other hazards read all

warnings and instructions included with and on the fixture box and all

fixture labels.

• Before installing, servicing, or performing routine maintenance upon

this equipment, follow these general precautions.

• Commercial installation, service and maintenance of luminaires should be

performed by a qualified licensed electrician.

• DO NOT INSTALL DAMAGED PRODUCT!

WARNING:

RISK OF ELECTRICALSHOCK

• Turn off electrical power at fuse or circuit breaker box before wiring fixture

to the power supply.

• Turn off the power when you perform any maintenance.

• Verify that supply voltage is correct by comparing it with the luminaire label

information.

• Make all electrical and grounded connections in accordance with the National Electrical

Code and any applicable local code requirements.

• All wiring connections should be capped with UL approved wire connectors.

CAUTION:

RISK OF INJURY

• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,

servicing or performing maintenance.

• Avoid direct eye exposure to the light source while it is on.

• Account for small parts and destroy packing material, as these may be hazardous to children.

CAUTION:

RISK OF FIRE

• Keep combustible and other materials that can burn away from luminaire and lamp/lens.

• MIN 90°C SUPPLY CONDUCTORS.

• Disconnect power and allow fixture to cool before changing bulb or handling fixture.

Models:

BLHE Series

12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com

Page: 1

REV: 06/12/18

General Safety Information

Picture is for illustration purposes only.

Your model may vary.

Summary of content (4 pages)

PAGE 1
Operating Instructions BLHE Series MaxLite® BayMax Linear High Bay Eco Series General Safety Information • To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels. • Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
PAGE 2
Operating Instructions BLHE Series MaxLite® BayMax Linear High Bay Eco Series General Wiring Diagram CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply. Connecting panels to AC source supply: All units must be individually connected to the AC supply. (120-277 VAC) Black = Line / White = Neutral / Green = Ground Installation & Operation Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the fuse box.
PAGE 3
Operating Instructions BLHE Series MaxLite® BayMax Linear High Bay Eco Series Installation & Operation C: Surface Mounting Installation (mounting kit available separately) Materials Required (Figure C-1): One (1) LED fixture BLHE Two (2) surface mount brackets (not included) Four (4) anchors (not included) Four (4) Tapping screws (not included) Four (4) hexagonal head screws (not included) 1. Place the surface mount bracket as shown in Figure C-2. 2.
PAGE 4
Operating Instructions BLHE Series MaxLite® BayMax Linear High Bay Eco Series Warranty Information MaxLite Inc. warrants its products for a minimum period of FIVE (5) years from the date of original purchase from MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with the same or like Product.