Owners Manual

© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 11/22/17
Installation & Operation - Double-Ended Wiring
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
Step 1: Make sure the circuit breaker that supplies power to the fixture is turned off.
Step 2: Remove lens or diffusion cover on the lighting fixture.
Step 3: Remove the existing T8/T12 florescent tubes.
Step 4: Remove the ballast cover and identify the line and neutral wires running from the breaker
box to the ballast and confirm the power is off using a voltmeter.
Step 5: Cut the line and neutral wires at the ballast, as well as all remaining wires
at the ballast (see Figure 1).
Step 6: Remove Ballast (and starter if present). Dispose of removed ballast in
accordance with government regulations in your area.
Step 7: For double-ended wiring, please see Figure 3a, 3b, 3c or 3d.
Step 8: Reinstall the ballast cover to hide all wire.
Step 9: IMPORTANT: Peel off the provided caution label and install on a
visible location inside the fixture.
Figure 3a
Figure 3b
Figure 3c
Figure 3d
Operating Instructions L13T8EX4xx & L18T8EX4xx Series
MaxLite External LED T8 - 4FT
®
Or
DC Lin (370mA) - Vin (45V)
DC Lin (370mA) - Vin (45V)
Kit Model: L18T8EX4xx(DDR2L18) or L18T8EX4xx(DDR4L18)
Lamp Model: L18T8EX4xx “xx” = CCT: 35, 40 or 50
DC Lin (270mA) - Vin (45V)
DC Lin (270mA) - Vin (45V)
Kit Model: L13T8EX4xx(DDR2L13) or L13T8EX4xx(DDR4L13)
Lamp Model: L13T8EX4xx “xx” = CCT: 35, 40 or 50