Owner's Manual

Wiring Diagram
I
nst
al
l
at
i
on
I
ns
t
r
uct
i
ons
Always turn off the power supply from main circuit breaker first!
B: Chain Mounting with V hook:
Attach customer supplied V-Hooks to each end of the luminaire base. Attach customer supplied
chain to the V-hooks and mounting surface.
C: Surface Mounting:
Secure luminaire base to mounting surface by inserting customer supplied #8 anchor screws, toggle bolts or
suitable fasteners, depending on structural conditions, into key hole slots on the top side of the luminaire base.
D: T-Bar Clip Mounting Hole:
Attach customer supplied T-Bar clips to the designated opening on the luminaire as show in Figure 2.
Bring luminaire into T-Bar ceiling grid and secure luminaire to grid.
NOTE: (Please see Figure 1, Rear of Base is provided with holes for mounting.)
Operating Instructions LS Series
MaxLite LS Series
®
Note: Knock out is 7/8th inch (1/2” NPS standard)
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 1/25/18