Owners Manual

Mounting Instructions
Before installation, ensure if power supply is disconnected. Cables must be connected in accordance
to instruction and proper standing rules.
5. For rear access points feed wires through hole.
6. Using 1” mounting screw or 3”x3/16 toggle bolts, secure fixture in place using keyhole slots provided.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 05/03/18
Operating Instructions LSU Series
MaxLite LED Utility Wrap Fixture
®
Lens
Cover
Driver
N
L
Screw
7. After making wiring connections, replace wire cover and diffuser into place.
8. Secure lens to housing by inserting clips at both ends of the fixture, as shown in the image below.
9. Restore power to branch circuit and energize the luminaire.
Metal Clips