Owners Manual

Setting & Adjusting Motion Sensor
Operating Instructions LSU Series
MaxLite LED Utility Wrap Fixture
®
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 5
REV: 05/03/18
To make setting and control adjustments, you will need to access the three rotary DIP controls behind the lens.
Control Mode
The LOD-500 series features 8 different control modes
for selection via rotary DIP switch. Please refer to the
following table and sensor operation charts to select the
desired control mode.
SW. ABCDE F G H
0SMA0SLA0S0TESTMODE 0SHA 0SLAT0 0SMAT0 0SHAT0
A
B
C
D
E
F
G
H
MODE
(TEST)
1
2
3
4
5
60
1
2
3
4
5
60
MODE
TIME DIM
TIME
(10 minutes)
DIM
(OFF)(Factory set)
POS.
TIME
DIM
0123456
1’ 3’ 5’ 10’ 15’ 20’ 30’
OFF 5% 10% 20% 25% 33% 50%
Delay Time
The LOD-500 series offers 7 different delay
time settings via Accu-Set potentiometer.
The light will remain ON if sensor detects
occupant’s movement before the set delay
time expires. The Accu-Set potentiometer will
provide accurate delay time as the arrowhead
pointed.
Dim Level
The LOD-500 series offers 7 different dim
level settings via Accu-Set potentiometer.
The LED light will be dimmed as the level set
when condition of selected control mode
applies. The Accu-Set potentiometer will
provide accurate dim level as the arrowhead
pointed.
Sensor Operation
Default
Parking
Profile
Default
Stair
Profile
Battery Backup Option
Your MaxLite Utility wrap fixture may come equipped with a battery back up power system.
Please review all following remarks to prevent any damage or risk while installing or using your fixture:
This Option is covered under UL 1598 and is a factory assembled system. Any field installation will void the factory
warranty unless express written authorization is given in advance.
Contains Nickel-Cadmium Rechargeable Battery. Must be recycled or disposed properly.
Output LVLE Compliant
Please note, your control is equipped with a quality
neoprene seal. This seal does expand over time
providing maximum sealing protection possible. If you
have any trouble re-installing the lens, a light coating
of WD-40 as lubricant, to the seal, will make installing
the lens easier. Care should be taken NOT to spray
lubricant into the DIP switches.