Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
General Wiring Diagram
CAUTION: Turn off electrical power at fuse
or circuit breaker box before wiring fixture to
the power supply.
Connecting panels to AC source supply:
All units must be individually connected to
the AC supply. (120-277 VAC)
Black = Line
White = Neutral
Green = Ground
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. Bend out mounting tab 90 degrees on each corner.
2. Use side cutters to adjust each tab to height of T-grid. Lay fixture into T-gird grid.
3. Bend tabs flush against T-grid in order to clear corner for ceiling tile.
4. Ensure that the wiring of the last fixture in the row is properly terminated.Then make all electrical
connections to the fixture.Attach the wiring access cover plate.
Operating Instructions ECO-T Series
MaxLite ECO-T LED Recessed Troffer
®
Page: 2
REV: 12/20/16