Installation Sheet

ManualsBrandsMaxLite ManualsLightingUniversal Downlight 6" LED Baffle Trim Integrated Recessed Fixture

Table Of Contents

Operating Instructions RCF Universal Downlight Series – CCT Selectable

MaxLite Universal Downlight RCF Series – CCT Selectable

12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com

Page: 1

REV: 3/25/21

Picture is for illustration purposes only.

Your model may vary.

Models:

RCF SERIES

120-277V, 120V Triac dimming

50/60 hz

WARNING: RISK OF ELECTRICAL SHOCK

• Turn off the electrical power at fuse or circuit breaker box before wiring

fixture to power supply.

• Turn off the power when you perform any maintenance.

• Verify that supply voltage is correct by comparing it with the luminaire label information.

• Make all electrical and grounded connections in accordance with the National Electrical Code and

any applicable local code requirements.

• All wiring connections should be capped with UL approved wire connectors.

CAUTION:

• Don't replace any accessory to prevent from dropping, electric shock or fire. etc.

• Don't touch the lamp when in use.

• Always switch off the mains supply. 5-10 minutes later to replace the lamp after the used lamp has

cooled down.

• Lamps should only be used in a protective shield!

CAUTION: RISK OF INJURY

• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing

or performing maintenance.

• Avoid direct eye exposure to the light source while it is on.

• Account for small parts and destroy packing material, as these may be hazardous to children.

CAUTION: RISK OF FIRE

• Keep combustible and other materials that can burn away from luminaire.

• MIN 90°C SUPPLY CONDUCTORS.

Operating Temperature: -4°F to 104°F (-20C° to 40°C)

Damp Location Rated

General Safety Information

• Before installing, servicing, or performing routine maintenance upon

this equipment, follow these general precautions.

• To reduce the risk of death, personal injury or property damage from fire, electric

shock, falling parts, cuts/abrasions, and other hazards read all warnings and

instructions included with and on the fixture box and all fixture labels.

• Commercial installation, service and maintenance of luminaires should be

performed by a qualified licensed electrician.

• For Residential installation: If you are unsure about the installation or

maintenance of the luminaires, consult a qualified licensed electrician

and check your local electrical code.

• DO NOT INSTALL DAMAGED PRODUCT!

• This fixture is intended to be connected to a properly installed and grounded

UL listed junction box.

Summary of content (8 pages)

PAGE 1
Operating Instructions RCF Universal Downlight Series – CCT Selectable MaxLite® Universal Downlight RCF Series – CCT Selectable General Safety Information • Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
PAGE 2
Operating Instructions RCF Universal Downlight Series – CCT Selectable MaxLite® Universal Downlight RCF Series – CCT Selectable General Wiring Diagram CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply. Input Rating: 120-277V 50/60 Hz Black = Line White = Neutral Green = Ground (+) LINE (-) COMMON GROUND BLACK WHITE GREEN / YELLOW-GREEN Light Fixture Retrofit Installation 1.
PAGE 3
Operating Instructions RCF Universal Downlight Series – CCT Selectable MaxLite® Universal Downlight RCF Series – CCT Selectable New Construction Installation 1.) Make sure the POWER IS TURNED OFF at the source to the recessed frame in which you are installing the product. 2.) Attach the carabiner safety clip to a structural support (Figure 1) 3.) Insert lamp conduit into the J-box and wire to power source (black to hot, white to neutral, green to ground) (Figure 2) Reattach J-box cover when done. 4.
PAGE 4
Operating Instructions RCF Universal Downlight Series – CCT Selectable MaxLite® Universal Downlight RCF Series – CCT Selectable Warranty Information MaxLite Inc.
PAGE 5
Mode d’emploi Série RCF universelle d’éclairage vers le bas – CCT sélectionnable MaxLite® RCF universelle d’éclairage vers le bas – CCT sélectionnable General Safety Information • Avant l’installation, la réparation ou la réalisation des opérations ordinaires d’entretien de cet équipement, suivez ces précautions générales.
PAGE 6
Mode d’emploi Série RCF universelle d’éclairage vers le bas – CCT sélectionnable MaxLite® RCF universelle d’éclairage vers le bas – CCT sélectionnable Consignes générales de sécurité PRÉCAUTION: Débrancher l’alimentation électrique au fusible ou au disjoncteur avant de connecter le luminaire à la source d’alimentation.
PAGE 7
Mode d’emploi Série RCF universelle d’éclairage vers le bas – CCT sélectionnable MaxLite® RCF universelle d’éclairage vers le bas – CCT sélectionnable Installation dans une nouvelle construction 1.) S’assurer que l’ALIMENTATION EST COUPÉE à la source des boîtiers d’encastrement dans lesquels les luminaires seront installés. 2.) Attacher le mousqueton de sécurité à un support structurel. (Figure 1) 3.
PAGE 8
Mode d’emploi Série RCF universelle d’éclairage vers le bas – CCT sélectionnable MaxLite® RCF universelle d’éclairage vers le bas – CCT sélectionnable Informations de garantie MaxLite Inc.