Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. Turn off the power before installation, Remove the diffuser existing bulb if
necessary and remove the existing trim. Attach the relamping label to the
inside of recessed luminaire housing.
2. As shown in Figure 1, Twist the lamp base into the lamp holder.
3. As shown in Figure 2, Connect the lamp connector with lamp base connector.
4. As shown in Figure 3, Push the LED retrofit trim into the recessed light fixture,
allowing the mounting clips to pull the LED trim up into the recessed light fixture.
Continue to push the LED trim until its outer edge is flush against the ceiling surface.
4 inch:
RR-409U-XXY
6 inch:
RR-613U-XXY
Operating Instructions RR-U Series
MaxLite LED Downlight Retrofit
®
Page: 2
REV: 10/27/16