Owner's Manual

Operating Instructions LED T8 U-Bend DirectFit Lamps
MaxLite LED T8 U-Bend DirectFit Lamps
DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION
WARNING – RISK OF FIRE. Use only in place of fluorescent lamps specified on label.
These devices are not intended for use with emergency exit fixtures or emergency exit lights.
•
SUITABLE FOR DAMP LOCATIONS
•
DIRECT REPLACEMENT FOR 32W/23T8/U6 LAMPS ONLY
•
CAUTION - RISK OF FIRE. USE ONLY IN PLACE OF FLUORESCENT LAMPS SPECIFIED ON LABEL
•
CAUTION RISK OF FIRE - IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION
(BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER, REMOVE LAMP FROM LUMINAIRE
AND CONTACT MANUFACTURER.
•
DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
•
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN
THE LUMINAIRE IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND CONTACT LAMP
MANUFACTURER OR QUALIFIED ELECTRICIAN
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 1
REV: 5/09/17
®
G
en
er
al
Safety
I
n
fo
rm
ati
o
n
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Installatio
n
In
str
uctio
n
s
1.) Turn off the power to the luminaire.
2.) Remove diffuser (if provided).
3.) Remove the existing fluorescent lamps from the luminaire.
Dispose the existing fluorescent lamps in accordance with government regulations in your area.
4.) Install MaxLite LED T8 U-Bend DirectFit lamps. Ensure that the pins are firmly seated in the lampholders.
5.) Ensure lamp is secured by clip.
6.) Replace diffuser (if removed in step 2).
7.) Switch on power to the luminaire.
MaxLite offers a warranty on this product, please see: http://www.maxlite.com/resources/warranties for more information.
LED Lamp Warranty
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that
may cause undesired operation
Step 1 Step 2-3 Step 4 Step 5-6
Step 7