Installation Sheet

Installation & Operation – Conduit Mounting:
1. If there is an existing fixture remove it. Loosen
both outer side screws, but do not completely
r
emove them (see Fig. 1).
2. Open the heatsink to reveal the inner side screws.
Remove the inner side screws to access the driver
box (see Fig. 2).
3. Unscrew either the right or left side knockout plug.
Drill four (4) holes in the corners of the back
housing. Fasten the back housing to the wall
with bolts.
4. Run the main power wires through the open
knockout hole and connect them to the driver
according to the wiring diagram.
5. Before closing the fixture, select the desired CCT
by using the switch on the front driver box housing.
Connect the main power to the driver according to
the wiring diagram. Finally close the fixture
ensuring that all wires are inside, and using a
suitable screwdriver retighten the inner side
screws. Adjust the heatsink to the desired angle
and retighten the outer side screws.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 4
REV: 11/18/21
Operating Instructions WP-ADS Series
MaxLite WallMax™ Thin Cutoff Wall Pack
®
O
uter
S
ide Screws
Inner
Side Screws
Note: Built in level
helps ensure
straight
mounting