Owner's Manual

Installation & Operation - Conduit Mounting:
1. Unscrew the screws on the right side using a
suitable screwdriver. Seperate the male and
female connectors, then remove the reflector
from the back plate.
᧤᧥
2. Unscrew the right-side Bolt(5). Drill three 6.5mm holes in E/F/G
using a suitable drill. Next, fasten the back plate to the wall with
the three screw components.
Operating Instructions WP-OP Series
MaxLite WallMAX Wall Pack
®
3. Run the main power through the right hole and
then finish the wiring (Black wire - L, White wire -
N, Green wire - G) See wiring diagram on page 2.
4. Use the hinge to lock the reflector to the back plate firmly. Next,
connect the male and female connectors together. Finally, use a
suitable screwdriver to connect the reflector to the back plate.
Installation & Operation - Conduit Mounting with Cover Plate
1. Unscrew the screws on the right side using a
suitable screwdriver. Seperate the male and
female connectors, then remove the reflector
from the back plate.
2. Unscrew Knockout Cap (1), and drill ¼” hole into the 3 places
indicated in the figure below. Then insert the ¼” screws
provided with the plate and use the lock nut washers on the
inside of the fixture to secure it to the plate.
3. Feed power from the building though the center
hole of the plate and the knockout hole that was
opened in step one.
4. Secure the plate and fixture to the wall using 4,
¼” screws in the corner holes of the cover plate.
(¼” screws not provided.)
5. Use the hinge to lock the reflector to the back plate firmly, then
connect the main power. Black wiring to L, White to N, Green to
G (see diagram above.), and connect the male and female
connectors together. Finally, use a suitable screwdriver to
connect the reflector to the back plate.
Note: If the Wall pack has an internal emergency driver, use the 2nd installation instructions - Conduct Mounting.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 1/18/18
1