Owner's Manual

Emergency Driver Installation
1. For 28W an 40W, 10'' size:
Positions NO #1, 2, 3, 4 to fix Emergency driver.
(To put the emergency battery on the top of
emergency driver and use a cable tie to band
these two together). See Figure 1.
Positions NO#5, 6 to fix regular driver
(AC100-277V)
28W/40W Emergency Battery, Part NO#:
FHSBATL3-1.5S
28W/40W Emergency Driver, Part NO#:
FHS2-UNV-56S-2015-574+
( , )
- -
( / / / / / )
2. Positions NO#7, 8, 9, 10 to fix
Emergency driver. (To put the emergency
battery next to the emergency driver
and use a cable tie to band these two
together.) See Figure 2.
- Wireframe NO#11 to fix regular
driver AC100-277V.
40W/50W/60W/80W/100W/120W
Emergency Driver,
Part NO#: FHS2-UNV-56S-2015-574+
40W - 8W Emergency Battery, Part NO#: FHSBATL3-1.5S
50W/60W-14W Emergency Battery, Part NO#: FHSBATL6-1.5L
80W/100W/120W - 20W Emergency Battery, Part NO#: FHSBATL6-3L.
After the Emergency driver is attached to the Back plate use Conduit
Mounting. If Junction Box Mounting, mount the Back Plate
against the wall first and then attach the Emergency driver.
Operating Instructions WP-OP Series
MaxLite WallMAX Wall Pack
®
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 4
REV: 1/18/18