Installation Instructions

ManualsBrandsMaxLite ManualsLighting & Ceiling Fans30W LED Precision Wall Pack 175W MH Equivalent

Operating Instructions WP-WMP Series

MaxLite LED WallMax Precision Wall Pack

• To reduce the risk of death, personal injury or property damage from

fire, electric shock, falling parts, cuts/abrasions, and other hazards

read all warnings and instructions included with and on the fixture

box and all fixture labels.

• Before installing, servicing, or performing routine maintenance upon

this equipment, follow these general precautions.

• Commercial installation, service and maintenance of luminaires

should be performed by a qualified licensed electrician.

• DO NOT INSTALL DAMAGED PRODUCT!

• This fixture is intended to be connected to a properly installed and

grounded UL listed junction box.

WARNING:

RISK OF ELECTRICAL SHOCK

• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.

• Turn off the power when you perform any maintenance.

• Verify that supply voltage is correct by comparing it with the luminaire label information.

• Make all electrical and grounded connections in accordance with the National Electrical Code

and any applicable local code requirements.

• All wiring connections should be capped with UL approved wire connectors.

CAUTION:

RISK OF INJURY

• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing

or performing maintenance.

• Avoid direct eye exposure to the light source while it is on.

• Account for small parts and destroy packing material, as these may be hazardous to children.

CAUTION:

RISK OF FIRE

• Keep combustable and other materials that can burn away from luminaire and lamp/lens

• MIN 90°C SUPPLY CONDUCTORS.

Operating temperature: -22°F - 104°F (-30°C - 40°C)

BBU Models: 50°F - 122°F (10°C - 50°C)

Model Numbers and Description:

Where:

@@ = Wattage (30, 60, 90W)

# = Voltage (U = 120-277V, H = 347-480V)

$$ = Distribution (T2)

%% = CCT (50)

& = Finish (B = bronze)

XXX (MS2 = motion sensor, PC=photocell, EM = battery backup, SS = surge suppressor)

Ex. WP-WMP30UT2-50B

12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com

Page: 1

REV: 02/20/17

Picture is for illustration purposes

only. Your model may vary.

General Safety Information

Summary of content (4 pages)

PAGE 1
Operating Instructions WP-WMP Series MaxLite® LED WallMax Precision Wall Pack General Safety Information • To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels. • Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
PAGE 2
Operating Instructions WP-WMP Series MaxLite® LED WallMax Precision Wall Pack General Wiring Diagram CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply. Note that the fixtures are supplied with two 105°C leads. The white lead is to be connected to the neutral and the black lead to the power (line) lead. Attach ground wire to junction box “GRD” by means of green screw.
PAGE 3
Operating Instructions WP-WMP Series MaxLite® LED WallMax Precision Wall Pack Installation & Operation (Continued) 7. Secure the door to the housing and apply weatherproof silicone sealant around the edge of fixture and junction box. Installation of BBU on Wall Pack 1. Take the BBU box and accessory screws out from the packing box, then mount the BBU box onto the right side of wall pack main housing with screws supplied. 2.
PAGE 4
Operating Instructions MaxLite® LED WallMax Precision Wall Pack WP-WMP Series Warranty Information MaxLite Inc. warrants its products for a minimum period of FIVE (5) years from the date of original purchase from MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with the same or like Product.