User's Manual

Maxon SM5102Radio
2.Adding or Deleting to P Scan List
If each Channel is included in P Scan Editable List, Channel Number would display P scan Icon. To add or
delete channel from P Scan Editable List, use P2 button.
■ Programming
When the SM-2000/5000 Series is powered from the programming interface, the MCU checks PC-program
Enable port. If the PC-program enable port is active status, the MCU enters programming Mode. The LCD
display” ProGram”
1. Reading
SM-2000 / 5000 assumes PC is ready to receive data. So, If user send the serial Commands though the
interface boards, SM-2000 / 5000 will transmit the data. During this sequence, the Red LED is flashed. In PC
program Reading Mode, the LCD displays “Prog-r”.
2. Writing
SM-2000 / 5000 assumes PC is ready to transmit data. If user send the serial Commands though the
interface boards, SM-2000 / 5000 will notify this situation and then make ready to receive the data from PC.
After that, the radio informed PC of this status, then PC starts the transmission of data. During this sequence,
the Green LED is flashed. In the PC program Writing Mode, the LCD displays “Prog-w”.
■ Clone
1.Push and hold UP button when radio turn power on. In this mode, radio will display “Master”. The mode is
the master wait mode.
2. Push and hold DOWN button when radio turn power on. In this mode, radio will display “Slave” with green
led blinking.
3.Connect the cloning cable.
4.Push the master radio DOWN button.
5.After cloning, the slave radio display “ TURN OFF” message, and the master radio display ” MASTER”
message on LCD.
4. BASIC FEATURES
■ 208Channels
The SM5000 Series radio can store up to 208 channels within the same band. These channels can be
selected by turning S/W.
■ Channel Spacing
The SM-5000 Series is capable of programmable channel spacing. Each channel can be programmed via
the PC programmer, having 12.5KHz or 25KHz channel spacing.
■ Output Power
Each channel can be programmed via the PC programmer and KEY to a high-power output, 50 Watts, and a
low-power output, 5 Watt.
■ Beep On/Off Mode
All Beep tones can be globally enabled or disabled via the PC programmer. Power Up alert shall be disabled
when Power UP Alert are globally disabled.
■ Light Mode
AUTO Mode/OFF Mode is Selectable using Key. In case of Auto Mode, as pressed the key, the light is bright
during the 5 s.
■ Public Address
When selected and external speaker is attached the radio will output voice audio over the external speaker.
The radio does not TX a carrier in this mode. P/A will be shown in display when selected. When active allows
operator to enable an external speaker and transmit microphone audio only.
■ Microphone Hook
Dealer programmable function. Turned OFF user is not required to ground microphone hook. All decode and
scan functions remain the same. Turned ON user is required to ground microphone hook. When microphone
is removed from ground all tone decode functions are disabled, scan function is dealer programmable as on
or off with microphone removed from hook. Default is off with scan disabled.